Mild alkaline liquid cleaner for mechanical reprocessing of medical devices. Residue-free, thorough cleaning with very good material compatibility. Low foam development and highest cleaning performance against typical soiling.
Mild alkaline liquid cleaner for mechanical reprocessing.
- Formulation with high material protection
- Excellent cleaning performance
- Efficient and economic
|Our performance||Your advantage|
|Specially developed formulation with high material protection||Very good material compatibility even against sensitive materials*|
|Powerful formulation components||Low foam development and highest cleaning performance against typical soiling from the medical area Economical due to low dosing.|
|Addition of corrosion inhibitors||Broad use spectrum over almost all materials used in the medical area|
|pH > 10 in the application solution at process temperature||Secure reprocessing of medical instruments|
In cleaning and disinfection devices in the medical area, depending on the water quality, can be used with 3-6ml/l preferably with DI water.
For surgical instruments and other medical instruments and accessories that can be thermally disinfected at 93 °C.
For reprocessing OP shoes and thermolabile medical materials at 45 to 60 °C.
Chemical thermal disinfection; with Sekumatic™ FD or Sekumatic™ FDR at 60 °C for 5-10 minutes.
When neutralization is needed (bad water quality) Sekumatic™ FNZ or Sekumatic™ FNP can be used.
Also suitable for reprocessing lab glass and baby bottles.
Neutralization may be done with Sekumatic™ FNZ or Sekumatic™ FNP. Thermal disinfection: For final rinsing, preferably use fully demineralized water (DI).
Sekumatic™ ProClean is based on sodium hydroxide, sequestrates, corrosion inhibitors, additives.
Sekumatic ProClean is based on sodium hydroxide, sequestrates, corrosion inhibitors, additives.
|Use (after commencement)||Shelf life|
Please note the following to ensure the correct storage of environmental hygiene and instrument disinfectants: The original containers (canisters, buckets or bottles) with the disinfectant concentrate (or powder) should be stored at temperatures below 25°C and kept dry and clean. A brief period below or above the given storage temperature (e.g. during transport) will not diminish the effectiveness. The containers are to be sealed tightly after each use. Please also take care that the concentrate remaining in the container is not contaminated when preparing the application solution.
EXCEPTIONAL CLEANING PERFORMANCE
Formulated to combine high cleaning performance with excellent material compatibility.
pH range between 10 and 10.5 to enable safe reprocessing of anodised aluminum.
No surfactant in the formulation means no foaming and thus no issues with cavitation in your WD.
Free from NTA, EDTA and Phosphates.
For cleaning surgical instruments and accessories in washer-disinfectors. For surgical instruments and other medical instruments that can be thermally disinfected. Dose 3 - 6 ml/L. For thermolabile medical devices. Dose 3 - 6 ml/L.
The product can be used without neutralisation when RO or demineralised water is used for the final rinse. If neutralisation is required dose approximately 1 - 3 ml/L Sekumatic™ FNZ
Sodium hydroxide, complexing agents, corrosion inhibitor and auxiliary substances
- Density (20°C): 1.26 g/ml pH-Value (undiluted, 20°C): approx.
- 12.0 pH-Value (diluted at 3 ml/L of demineralised water, 20°C): approx. 11.0
- Conductivity (diluted at 3 ml/L of demineralised water, 20°C): approx. 972 μS/cm
In the environmental safety assessment Sekumatic™ ProClean was evaluated as highly biodegradable for all organic components and phosphate-free. Discharge of small quantities into the sewage system will not exceed the pH limit values allowed. However, strong peak loads should be avoided.
The packaging is made from polyethylene or polypropylene plastic. It is made of non-recycled new raw materials in order to guarantee the necessary quality for medical applications. The plastic packages are labelled in order to facilitate recycling of the material.
The cartons consist of natural coloured, unbleached and largely recycled paper.
Based on the mass contents of its ingredients Sekumatic™ ProClean is classified as “corrosive”.
Disinfectant for medical devices